Leather Envelope Phone Case

1This DIY is super easy, the combination of basic materials and a printable template means even a novice crafter can produce this chic, simple phone case for themselves or as a gift in no time.2

Materials

leather

top-stitching thread

scissors

stitching awl

e6000 glue

needle

tape

cell phone case pattern

Instructions

  1. Print out cell phone case pattern. Lay onto leather, tape in place. Use stitching awl to poke holes as marked on the pattern.3
  2. Cut out pattern.4
  3. Hand stitch in and out around the leather through the poked holes (will create a dashed line effect, see photo).5
  4. Then, hand stitch in the same manner to fill in the unstitched areas. Be sure to overlap about 3 stitches to keep the stitches secure. 6
  5. Fold over the left and right triangle flaps. Sew together, making sure the 4 poked holes are aligned.7
  6. Add e6000 glue to the bottom flap, tuck inside, and glue in place.8
  7. Hold for a few seconds to allow the glue to set in.9

You’re done!10

Leave a Reply

Your email address will not be published. Required fields are marked *